6
In the terminal program you should now see a LogicLoader screen presenting text similar to
the one below.
Please refer to Section 11 for important information about the CPLD code.
dBUG> go ff840000
spi not initialized: cpld code not detected.
serial eeprom not initialized: cpld code not detected.
CPLD not programmed.
video-set-default: unable to open '/dev/serial_eeprom'
no default screen
*****************************************************************
LogicLoader
(c) Copyright 2002-2004, Logic Product Development, Inc.
All Rights Reserved.
Version 1.5.2-MCF5475_10 0001
*****************************************************************
Type 'help all' for a list of commands.
losh>
4.3
Using the Development Kit with the P&E ColdFire LITE BDM Interface
The Zoom ColdFire LITE Development Kit includes a ColdFire LITE BDM Interface from P&E
Microcomputer Systems that can be used with a variety of development tools. The installation
and use of the cable may vary between different development tool vendors.
In order to use the BDM with a particular toolset, please refer to readme files included with each
vendor’s development tools for specific instructions.
The BDM Interface should be plugged into the ETX board connector J10 (see Figure 2.3). Use
the included parallel cable included to connect the BDM to your PC’s parallel port. Refer to the
Pemicro website
for the latest information on configuring the BDM for
use with your PC.
4.3.1 Using the BDM with the GNU Cross Development Toolchain
In order to use the BDM with the GNU cross development toolchain provided by Logic, jumper J1
must be moved to position 1-2 (Labeled ‘No’ in the silkscreen) on the BDM.
Zoom ColdFire QuickStart Guide
10
