FREERIDER FR-S13 Series, Руководство пользователя, Страница: 11 / 29

IV. FR-S13 FEATURE GUIDE
11
ARMREST WIDTH ADJUSTMENT
SEAT HEIGHT ADJUSTMENT
SEAT SLIDE
HEADREST HEIGHT ADJUSTMENT
SAFETY BELT
On some models, scooter seat is fitted with a safety belt to prevent you from slipping
forwards under braking conditions or while going down a slope or over obstacles,
always use it-even for short journeys.
The lap belt can be adjusted on one side to fit comfortably around your waist. To fit,
simply connect the two buckles together until a distinct "click" is heard. To remove,
simply press the "red" buckle and the two belts will separate.
On each side at the rear of the seat, you will find a large black knob. By simply
loosening this knob you will be able to slide the armrests in or out to whatever width
you desire. Re-tighten the knobs fully.
You may need to alter the seat height setting at a later date, please
follow these instructions.
(A)Remove your seat from the scooter by lifting the seat.
(B)With the aid of a 16mm wrench loosen the 10mm seat clamp
(C)Re-tighten the 10mm fixing screw.
(D)Refit the seat onto your scooter.
Located on the right front side of the seat. The lever allows you to
adjust your seat forwards and backwards while sitting on the seat.
Simply pull up the lever and move in the desired position backwards
by pushing or forwards by hitching. As soon as the lever is released,
the seat will lock into the new position.
The upper cushion of your backrest can be adjusted for height, giving you more
back support if you are tall, by operating the small latch at the base of the left hand
round support bar. Lift the cushion up or push it down for the most comfortable
position. The headrest will also lift out for convenience.
SLEEP MODE
When your scooter has been idle for 15 minutes or more, it will automatically go into
sleep mode to conserve its battery life. The system can be woken from sleep mode
by turning the key switch.
fixing bolt from side of seat post. Remove the 10mm fixing bolt
and reposition the bolt into one of the four preferred location
holes of the seat mounting tube.