The tyre should be exchanged when the tread has worn out.
Remove the wheel from the fork with the aid of 19mm and
21mm spanners. The front wheel has two bearings which may
have various spacing washers between the fork, please note the
order of these washers.
Remove the tyre from the wheel by following point 6 above for
Rear Wheels, using a 13mm spanner and hex key. For
re-assembly, just reverse procedure making certain that all
washers supplied are replaced correctly.
The Scooter wheels are pneumatic and their pressure
needs to be maintained at 30 p.s.i. (210 kpa)
Pressures exceeding those recommended will result
in an uncomfortable ride. Underinflation will result in poor
battery and motor performance. Do not exceed the maximum
pressures marked on the side wall of the tyre, this could
damage the tyre or wheel rim.
The fitting of solid inserts into the wheels to
replace the pneumatic tube (puncture proofing) is not
recommended as these products detract from the natural
cushioned ride produced from 'air' filled tyres. If you require
puncture proof tyres, your dealer can, at an extra cost, insert
a liquid puncture proofing agent.
Keep your batteries well charged (see Battery Charging section
of this manual). Keep batteries clean and in a dry frost-proof
place. Keep battery terminals tight. Your
r Agent will
be able to test your batteries for their state of service.
a charge may be made for this service.
It is not possible to predict the life expectancy
of your batteries. This is mainly due to the different
workloads a battery can be subjected to.
Some
Scooter users will use their vehicle every day
and for long periods of time. Their batteries will receive a
near total discharge, and the life of the batteries will be short
Freeride
Note:
Freerider
(less than 12 months in some cases).
TYRE SERVICING FRONT WHEEL
TYRE PRESSURES
Warning:
Caution:
BATTERIES
IMPORTANT:
TYRE SERVICING FRONT WHEEL
TYRE PRESSURES
Warning:
Caution:
BATTERIES
IMPORTANT:
Freeride
Note:
Freerider
(less than 12 months in some cases).
FIG 33
Other Scooter users will use their machines less frequently,
putting their batteries through a less demanding discharge
lifestyle. These batteries will probably have a longer life in
excess of 12months). This can only be a general guide and
one cannot be more specific, due to other factors such as;
motor loads, tyre pressures, general service factors, working
conditions, periods of non-use and abuse etc.
When you need to purchase batteries, always insist on the
model fitted as standard equipment to your Scooter. Do not
use less expensive car starter batteries. If in doubt, consult
your local
authorised agent.
Correct disposal of exhausted batteries is advised.
Please note: The charger supplied with your
Scooter is specifically designed for sealed type batteries and
may not work correctly with other battery designs. (See also
Batteries and Battery Charging section of this manual).
The
Scooter has been designed with low
maintenance in mind. Wheel bearings and steering bearings
are sealed for life. The following points will need
checking/lubricating at the following service intervals:
Freerider
Freerider
Freerider
Check the following:
Operation of motor brakes
Operation of driving brake
Operation of seat lock
Tyre condition
Batteries are fully charged
Check chassis locking mechanism (see Fig 27 page 21 )
Arm rest tightening knobs (see Fig 2 page 8 )
Tyre pressures 30 p.s.i. 210 (kpa)
Battery fastening
Allow battery charger to go through a full recharge cycle
until the green light is illuminated (see page 23 )
Clean paintwork with auto shampoo. Do not use a high
pressure hose. Wax painted and bright metal parts.
Tyre wear, replace as necessary
All fasteners and fittings for sound function
Tension of handle bar lock and hinge bolt
Battery connections
Inspect all electrical plugs and sockets for damage and
good contact and fit.
Wig-wag accelerator lever pivot point (see Fig 34)
Only drive your
Scooter if it is in full
working order.
Freerider
Check and adjust as necessary:
Lubricate the following:
Check the following and adjust as necessary:
Warning:
LUBRICATION
RECOMMENDED SERVICE INTERVALS DAILY
Caution:
WEEKLY
SIX MONTHS
Front basket and any carrying accessory is firmly attached
Freerider
Warning:
LUBRICATION
RECOMMENDED SERVICE INTERVALS DAILY
Freerider
Freerider
Caution:
WEEKLY
SIX MONTHS
Freerider
Check and adjust as necessary:
Lubricate the following:
Check the following and adjust as necessary:
28
Содержание FR-168-3S
Страница 35: ...SIZE SPECIFICATION FR168 3 FR168 3S 35 ...
Страница 36: ...SIZE SPECIFICATION FR168 4 FR168 4S 36 ...
Страница 37: ...SIZE SPECIFICATION FR510DX2 FR510DXs2 37 ...
Страница 38: ...CIRCUIT DIAGRAMS CIRCUIT DIAGRAMS BATTERY WIRING DIAGRAM CIRCUIT DIAGRAMS 38 ...