27
How to Restore Default Settings
You can restore the following console settings to the
manufacturer’s default settings. The default settings
are indicated in parentheses:
• Unit of measurement (ENGLISH)
• Backlight duration (5 SEC)
• Contrast level (100 %)
• Auto pause setting (PAUSE ON)
• USB port setting (ON)
Select the RESET TO
DEFAULT menu option on
the firmware menu. The
word DONE will appear
in the message banner to
indicate that the console is
restored to the default settings.
HOW TO USE A BIKE NUMBER
Tip: It is strongly recommended that each exer-
cise bike in a fitness club be numbered for easy
identification.
To communicate properly, a paired console and sensor
must be mounted to the same exercise bike.
To make sure that the correct console stays with the
correct sensor and exercise bike, you can assign an
identification number to the console that matches the
identification number of the exercise bike.
If there is a communication problem between the con-
sole and the sensor, you can view the bike number and
make sure that the console is attached to the correct
exercise bike.
To assign the bike number,
see HOW TO ASSIGN
THE BIKE NUMBER at the right.
To view the bike
number,
see HOW TO VIEW THE BIKE NUMBER at
the right.
How to Assign the Bike Number
1. Activate the console and select the BIKE #
menu option.
See HOW TO ACTIVATE THE CONSOLE on page
11.
Then, see HOW TO USE THE SETTINGS MODE
on page 20.
The bike number will
appear in the message
banner.
2. Assign a bike number to the console.
You can assign a bike number from 1 to 99.
Press the AVG/END and Backlight buttons to
assign the desired bike number. Then, press the
STAGE button to confirm your selection.
3. Exit the bike number menu.
See HOW TO USE THE SETTINGS MODE on
page 20.
How to View the Bike Number
When the console is in the User mode, press and hold
the STAGE and AVG/END buttons. The bike number
assigned to the console will appear in the message
banner for as long as the buttons are held.
