PAGE 10
Preparing Cups for First Use
BOIL THESE PARTS
DO NOT BOIL THESE PARTS
ADDITIONAL INSTRUCTIONS
A:
Remove Cup from Flange
B:
Remove Valve Base
from Flange
C:
Remove Barrier from
Valve Base
D:
Remove Valve from
Valve Base
DISASSEMBLE
Disassemble and clean
Freemie Cups prior to first
use. Follow the instructions
below to sanitize these parts.
• DO NOT boil or steam these parts. Hand wash only.
• Hand wash Valve, Barrier and Insert parts using plenty
of hot water and liquid dishwashing soap, then rinse clean
with hot water for 10 – 15 seconds.
These parts do not come into contact with breast milk and
need not be washed unless they become soiled. If soiled, take
immediate care steps:
• The Y-Connector can be washed in hot soapy water, and
rinsed well.
• The Tubing or L-Connector can be rinsed with hot water.
Shake off excess water.
• Let parts dry thoroughly before use.
• Visually inspect parts to ensure they are clean and repeat
steps or replace part if cleaning was not successful.
Breast Flange
Valve Base
Valve
Cup
L-Connector
Barrier
Tubing
Y-Connector
• Boil only these hard parts for 10 minutes in large uncovered
pots while stirring constantly. (Covered pots or steam
sanitizer systems can damage parts.)
• Do not let parts sit on the bottom of the boiling pots.
• Parts should have enough room to float freely.
• Carefully remove parts from water with a non-metal
spoon and let cool completely.
• Wash parts after boiling and let dry completely
before assembling.
Insert
