background image

9

2.

On/Mute/Off Button

:

The wireless transmitter

(microphone or beltpack)

uses a single button for

“on”, “mute” and “off”.
Press the button for 1 second

for “on” (LED green), push

again for “mute” (LED orange),

push again to return to “on.”
Press and hold button for 2

seconds to turn off (LED off).

3.

Transmitter Channel Display

:

When transmitter is "on", momen-

tarily pressing the channel button

will illuminate the channel display.

(see page 10 for channel setting

procedure).

Confirm that the transmitter

and the receiver display the

same channel.

The ready LED on the receiver

should be illuminated.

4. Replace battery cover.

8

Wireless system operation.

The Freedom FR-3neo is available with single or dual

built-in Shure wireless receivers. The instructions on the

following pages describe how to set-up and operate the

receiver units and wireless transmitters.

Operating the optional wireless mic system.

The built-in wireless receiver(s) turn on automatically

when the Freedom is turned “on.” Note the location of

the wireless mic volume controls on the Freedom’s rear

panel. (There are no exterior antennas; they are built-in

to the receiver.)

Features and controls of the built-in wireless receiver.

audio

LED: Indicates strength of incoming audio signal:

green for normal, amber for strong, red for peak.

ready

LED: Green light indicates wireless system is receiving signal.

Channel number readout: See “Setting the receiver channel” on page 10.

channel

button: See “Setting the receiver channel” on page 10.

Setting-up the wireless transmitter and receiver.

1.

Install battery

: If you haven’t

installed the battery, do it now and

leave the cover off.
Expected life for a 9 volt alkaline

battery is approximately 8 hours.

When the Power/Mute LED on the

transmitter glows red, the battery

should be replaced immediately.

channel

ready

audio

1

2

3

4

1

2

3

4

wireless 1

wireless 2

Содержание Freedom FR-3neo









Отзывы: