Freedom Lite Home and Business HV Installation Manual Revision 1
P a g e
9 | 25
visible. This pre-tightening prevents the bolt from being pushed into the wall when
mounting the Lite.
The Freedom Lite has two keyhole shaped holes on the back, which are
shaped to fit over the bolt heads and then a narrowed section secures around the bolt
shank as the unit is lowered into its final position. The 15/11HV and 20/14HV models are
hung using M8 bolts whilst the 30/21 model is hung on M10 bolts. The larger models are
not equipped with keyholes and must be mounted upright on the floor. The centre to centre
spacing of these bolts must be applicable to the model being installed. It is critical that these
bolts are mounted within 1mm of the correct dimension and must be
perfectly level
.
Figure 4.1 Bolt Mounting Keyhole on Rear of Lite Casing – floor mount retaining tab and
fitted eye bolt also visible
Eye bolts fixed to the top of the battery can be used for hoisting the unit up to the required
height for fitting to the wall. The eye bolt on the models up to the Lite 20/14 can be
removed after installation. Ensure that you have one M12 x 1,75 thread eye bolt rated for
450kg or more for the models that are not supplied with permanently fixed eye bolts.
Lifting the batteries by the eye bolts should be performed using a mobile gantry crane or a
high lift pallet jack.
Figure 4.2 Eye bolt Example
