eTower Installation Manual Revision 0
P a g e
9 | 23
2.2.15
On/Off indication LED
On/Off indication LED – This LED is illuminated green whenever the battery management
system (BMS) is active.
2.2.16
Plastic Pedestal
The moulded plastic pedestal is a Freedom Won innovation that allows rapid installation on
site by stacking the modules into a tower using the pedestal as an interface between each
module as well as a convenient stand, upon which to place the bottom module. The
pedestal is designed to structurally withstand the weight of up to six modules placed into a
tower, however in most instances a system that requires this many eTower modules would
be better served by the Freedom Won LiTE Home and Business range of high-performance
batteries.
2.2.17
CAN Bus Communication Cable
In this photo the battery is shown with a CAN Bus cable, which is connected to a CAN Bus
compatible inverter system. This cable is part of the included accessories. See 2.2.14.
2.2.18
DC Power Cables
The power cables supplied with the eTower are 35mm
2
in cross sectional area. Ensure that
sufficient of these cables are used to match the power of the connected inverters or DC
chargers. The positive cable is red, and the negative cable is black.
2.2.19
Earthing Point
For eTower modules installed into a cabinet this earth point may be used to ground all
module casings to the cabinet ground.
3.
Detailed Specifications
Table 2.1 provides an overview of important data pertaining to the eTower e5000 modules.
The table provides data specific to the four configurations i.e. a single e5000 module, two
modules stacked together, three modules stacked together, and four modules stacked
together.
Table 2.1 eTower Specification Sheet (next page)
