Page 2 of 2
MAINTENANCE
Use a clean soft cloth, mild soap, and water to clean the lens.
NOTE:
FRC LED lampheads use Lexan lenses and cleaning with abrasive materials, solvents, or most chemical cleaners
can cause lens surface degradation and reduced performance of the light.
Some chemicals will cause the lens to
become brittle and prone to cracking.
REMOTE CONTROL PAIRING:
The default state for the light is to be unpaired to any remote control. However, the light can be paired to any remote control, and it is open to
being paired to any remote control. To avoid interference from other remote control devices that are within range, it is highly recommended
to pair the light to a remote control. (
2 remote controls are supplied with each light
.)
Pairing Steps:
1. Turn the light 'ON' by pressing the 'ON/OFF' button.
Within 1
minute
*, the light can be paired with any remote by pressing
and holding the 'ON/OFF' button on a remote control for 6
seconds. (For this example, this is referred to remote #1.) Once
remote #1 is paired to the light, the light will flash 3 times (as 3
long flashes) and then the light will turn off. Pairing is complete.
2. Remote #2 can be paired as instructed in step 1.
3.
Only 2 remotes can be paired to each light
. If a third remote
is paired to the same light, the first remote will get unpaired
from this light.
Unpairing Steps:
Removing pairing means that the light will not be paired to any
previously paired remote controls, and can be controlled by any
unpaired remote within operating distance. This is the default
mode for the light.
1. The remote can be unpaired whether the light is 'ON' or 'OFF'.
2.
Within 1 minute*
of turning the light 'ON' or 'OFF', press and
hold the 'ON/OFF' button on the remote for 6 seconds.
3. The light's LEDs will flash for as 3 short flashes and then the
light will turn 'OFF'.
4. The light is now unpaired from the remote and will reset to the
default mode (as mentioned above).
*NOTE
: The pairing or unpairing process will timeout
after 1 minute of inactivity.
BATTERY COMPARTMENT
(1) A23 battery (12V) *Note: (1) battery
is supplied for each of the (2) remotes.
9.3 inches
7.9 inches
7.9 inches
9.6 inches
45˚
70˚
REMOTE (Front)
REMOTE (Back)
Remote Holster
:
surface mountable
with 3mm or #4
fasteners (2 fasteners
are required)
244mm
LED400-Rev191118
