Document Number
XM-LED4PM-R0A
SAFETY SUMMARY
FRC lighting products are engineered and manufactured with safety in mind. It is
critical that FRC lights are installed, maintained, and operated correctly. Read and
understand all instructions before installing, performing maintenance, or operating.
All components, equipment, and installation procedures shall conform to
NFPA 1901,
Standard for Automotive Fire Apparatus
and NFPA 70
National
Electrical Code
.
General Safety Precautions
Do not stare directly at LEDs when power is on. Ensure power is off prior to connecting or disconnecting
wires/cables and plugs to a power source or performing maintenance. Disconnect ground connection from battery marked '-' to avoid accidental
short circuits before attempting to connect electrical wires.
Installation Safety Precautions
Connect the LED light to a 12 or 24 volt DC power source. Ensure an appropriate sized circuit protection device is installed (circuit breaker or
fuse). See Specifications below.
MODEL LED400 SERIES
LED400-Rev191118
FIRE RESEARCH CORPORATION
26 Southern Blvd., Nesconset, NY 11767
TEL 631.724.8888 FAX 631.360.9727
TOLL FREE 1.800.645.0074
www.fireresearch.com
LIGHTING
PRODUCTS
DESCRIPTION:
The Vantage Point light is a rotatable, remote-controlled LED light. The wireless remote allows the light to be remotely adjusted by the operator.
It has a vertical tilt up of 70˚ and 45˚ tilt down (diagram on page 2.) Horizontal rotational range is infinite (clockwise and
counterclockwise
). This
allows for a pan-tilt motion.
Also equipped with a flashing alert feature, which can be used to warn approaching motorists or pedestrians of potential hazards or help is needed.
It can also be used with service vehicles to alert the on-coming vehicles there are people at work, and more.
Stow Feature: with DC power on and connected, the light will automatically resume to the forward facing position after turning it 'OFF'. If power
is shut down from the apparatus while the light is still 'ON', the light will resume to the forward facing position after it is turned back 'ON'. The
light has 16 LEDs. Available with a black or white housing.
REMOTE CONTROL KEYPAD OPERATION:
The remote control is used to control the operation of this light and features six (6) buttons in total. The ON/OFF button (bottom left button)
will illuminate the LEDs or shut them off. The direction of the light is controlled by the arrow buttons: pan/tilt by pressing the up, down,
left and right arrow buttons. The bottom right button with the "F" controls the Warning/Flash pattern light beam.
1. ON/OFF—Press the ON/OFF to power the light on or off. When the light is OFF, this disables all button functioning.
2. Up Arrow—Press and hold the UP arrow to raise the light beam; the light will rotate upward to a maximum of 70˚.
3. Down Arrow—Press and hold the DOWN arrow to lower the light beam; the light will rotate downward to a maximum of 45˚.
4. Left Arrow—Press and hold the LEFT arrow to pan left.
5. Right Arrow—Press and hold the RIGHT arrow to pan right.
6. Warning Signal— Flashing LED (Flashes 3 long, 3 short). The light will flash 6 times in 1 minute, and repeats every 6 to 8 seconds.
To disable warning signal, press it again and the light returns to normal function.
XE-LED400-A06-B (Black) or XE-LED400-A06-W (White)
UP
LEFT
RIGHT
DOWN
WARNING
FLASH
ON/OFF
INDICATOR
(2) Remote Controls Supplied
SPECIFICATIONS:
1. Operating Voltage: 10 - 30VDC
2. Power Consumption: 80W
3. Maximum Distance for Operating Remote Control: Up to 130 ft.
4. Weight: 7 lbs. (3.2KG)
5. Remote Control Battery: (1) A23 battery (12V)
