PRO-S Rev1104
18
System Options
High Idle
Note: If the optional remote high idle kit is not being installed, ensure that the
high idle cap (supplied) is installed on the end of the control module high
idle cable.
The RPM that the engine will run at when the high idle circuit is engaged is set by
adjusting the 2500 ohm potentiometer. Refer to Calibration section if the potentiometer
has to be adjusted.
To engage the high idle, place the high idle switch to ON. The high idle indicator
light will go on and the engine will run at the set RPM. The PRO-S SETTING display
will show the high idle RPM.
With the high idle switch set to on, the PRO-S controls will operate normally for
RPMs above the high idle RPM. The
DECREASE
and
IDLE
buttons will not lower
the engine RPM below the high idle setting.
It is recommended that the high idle switch be set to OFF when operating
the pump.
CAUTION: The high idle switch must be off before shutting the engine off.
Failure to do so could result in damage to equipment.
