FRC DRY GEAR PLUS, Сборка и руководство по эксплуатации

Страница: 18 / 32

DGA200 Rev160525
18
Assemble Manifold, Tent Frame, and Muffler
NOTE : Muffler may be installed on the blower assembly from the factory.
Parts Needed
1-Muffler (3)
10-Socket Cap Screw, 1/4-20, 1 1/4 inches (1)
4-Socket Cap Screw, 1/4-20, 3/4 inches (2)
14-Flat Washer, 1/4 inch
Procedure
1. Install manifold in transfer tube top with six screws (1) and washers.
NOTE:
For 7 station configuration mount the 60-inch tent frame long angle
side above the 60-inch manifold side.
2. Install tent frame with four screws (1) and washers.
3. Install muffler (3) on blower with four screws (2) and washers.
End Procedure