Page | 5
PROGRAMMING
1.
Enable cruise control by pressing the
ON
①
button.
2.
Accelerate by pressing
SET ACCEL
③
until reaching the desired speed. Release the button and the
speed will be maintained. Alternatively, the foot pedal can be used to increase speed, then briefly
press the
SET ACCEL
③
button to maintain the speed automatically.
3.
After each time the brake pedal is depressed, the vehicle will lose speed. Press
RES
②
and the
vehicle’s speed will automatically resume to its previously set level.
4.
Press the
COAST
④
button to decrease the speed to a lower
setting.
5.
Press the
OFF
⑤
button to turn cruise control off.
CABIN
All vehicles are equipped with an automatic transmission, power steering and power brakes. The V8 engine
displacement is 5.4 litres and an output of 255 horsepower, the V10 6.8 litres and of 305 horsepower.
IGNITION SWITCH
The ignition switch has 5 different key positions:
POSITION A (ACCESSORY)
allows the electrical accessories such as the radio to operate while the engine is not running.
POSITION B (LOCK)
turns off the engine and locks the steering wheel in place.
POSITION C (OFF):
The ignition is off.
POSITION D (ON)
:
All electrical circuits are operational. Warning lamps and indicators are illuminated.
POSITION E (START)
cranks the engine. Please release the key as soon as the engine starts.
BATTERY BOOST SWITCH
The Battery Boost Switch enables jump-starting the engine from the coach batteries
when the engine battery is drained. This switch is located to the left of the steering
wheel
①
or at the driver’s seat below the recline handle
②
. If the battery is too low
to start the engine, press and hold the Battery Boost/Auxiliary Start switch while
turning the ignition switch and release it when the engine starts.
AUTOMATIC TRANSMISSION
The gear selector is to the right of the steering wheel. The instrument cluster displays its current position. Your
foot must be depressing the brake pedal to shift from P (park) to R (reverse) or D (drive). The gear selector has
the following positions:
P
PARK
to start or turn off the engine. The key can only be pulled in this position.
R
REVERSE
to reverse the vehicle. The rear-view camera is activated automatically.
N
NEUTRAL
Select this position for towing only!
D
DRIVE
Most efficient for all normal driving conditions.
4
4
th
gear
For improved traction
2
2
nd
gear
To accelerate on slippery surfaces.
1
1
st
gear
Allows for maximum engine breaking. Does not shift into 1
st
gear at high speeds!
CAUTION:
We strongly recommend to use D in all driving situations!
TOW/HAUL
The Tow/Haul function optimizes the shifting performance and reduces the potential for
transmission overheating or failure due to excessive shifting when driving in mountainous
areas.
This provides extra power when going uphill and braking assistance from the engine
when going downhill to reduce the risk of overheating the vehicle’s brakes. Select this
function by pressing the button at the end of the shift lever.
CRUISE CONTROL
The RV is equipped with Cruise Control. The minimum speed required for its use is 50 km/h. We do not
recommend using Cruise Control on mountain roads because it would cause irregular shifting and accelerating
resulting in excess transmission wear and increased fuel consumption.
