STEP 1b
- Locate
Tree Section
“A”
and remove the protective caps that are on the top
and bottom of the pole (they can be replaced when you re-pack your tree). Insert Tree
Section “A” into the tree stand.
Make sure the pole is firmly inserted into the stand, and
then turn all three screws until contact is made with the pole. If Section “A” is not sitting
straight, then simply loosen the screws, adjust tree pole, and retighten the screws.
All the branches are connected to the
tree’s center pole by metal hinges (See Figure 2).
Remove the packing strap that is around the tree section and allow the branches to fall into
place. Shape the branches and individual tips on Section A to your overall preference.
STEP 2
- Locate
Tree Section “B”
and insert into the top of Tree Section “A”. Make sure
section “B” is seated securely into the top of section “A”. Remove the packing strap that is
wrapped around this tree section, same as you for Section
“A”. Allow the branches and
leaves to fall into place. Shape the branches and individual tips on Section B to your overall
preference.
STEP 3
- Locate
Tree Section “C”
and insert into the top of Tree Section “B”. Make sure
section “C” is seated securely into the top of section “B”. Remove the packing strap that is
wrapped around this tree section, same as you for Section
“B”. Allow the branches and
leaves to fall into place. Shape the branches and individual tips on Section C to your overall
preference.
3.
Light Set and Power Connection:
FIG 3A
Your tree is lighted with LED 5mm Rice lights that are pre-strung
on the tree at the factory. Please follow the lighting diagram (Fig 3A)
to assure that each tree section is connected properly
C
Your 7.5 ft. tree will have ONE extension cord plug with 3 Coaxial Ends. Each
Coaxial end is labeled #1, #2, #3 PLUG #1
Guide the male end of the coaxial cord (Plug #1) from
tree “Section C” and plug into the female end of the coaxial plug
labeled #1 that is attached to the 3-way transformer.
B
PLUG #2
Guide the male end of the coaxial cord (Plug #2) from
tree “Section B” and plug into the female end of the coaxial plug
labeled #2 that is attached to the 3-way transformer.
Guide the male end of the coaxial cord (Plug #3) from
tree “Section A” and plug into the female end of the coaxial plug
A
labeled #3 that is attached to the transformer.
PLUG #3
Insert
the 2-prong end of the cord, coming from 3 way Coaxial Cord,
into the female end of the power supply transformer. (Fig. 3B)
#1 #2 #3
FIG 3B
