Page 3
For technical questions, please call 1-888-866-5797.
Item 70027
Assembly Instructions
Read the ENTIRE IMPORTANT SAFETY INFORMATION section at the beginning of this document
including all text under subheadings therein before set up or use of this product.
1. Lay Frame Assembly on the ground
with Handle facing down.
2. With Nose Plate (1) laying flat, place Nose
Plate Extension (6) onto Nose Plate. Make
sure holes on both align properly.
Nose Plate
Extension
Nose
Plate
3. Insert a Bolt (20) from the inside pointing outward
through each upper hole in the Nose Plate and
Nose Plate Extension to act as an alignment tool.
4. Place each Strut (3) against back of Nose Plate and
hold Struts in place. Make sure that alignment Bolt
threads do not extend past the edge of the Struts.
5. Holding Struts against Nose Plate, slide Nose
Plate onto Frame (2). Align holes in Struts and
Frame with alignment Bolts and slide alignment
Bolts through to hold pieces in place. Make sure
the Struts are properly aligned. There should be
no Strut holes visible above the Nose Plate.
6. Place a Right Axle Bracket (5) on the outside of
the assembly, insert a Bolt through the lower hole
from the outside, and secure it in place with a Nut.
Strut
Nose Plate
Extension
Nose
Plate
Frame
Bolt
Nut
Right Axle
Bracket
7. Remove the alignment Bolt from the top of the
right side, reinsert it through the same hole
from the outside, and secure with a Nut.
8. Insert Axle (7) into Right Axle Bracket.
Axle
Right Axle
Bracket
9. Place a Left Axle Bracket (4) on the outside of the
assembly, insert a Bolt through the lower hole from
the outside, and secure it in place with a Nut.
Axle
Left Axle
Bracket
Bolt
10. Remove the alignment Bolt from the top of
the left side, reinsert it through the same hole
from the outside, and secure it with a Nut.
11. Place a Washer (22), Spacer (23), Wheel
(8), and another Washer onto the Axle.
Wheel
Washer
Spacer
Cotter
Pin
Axle
12. Place Cotter Pin (24) through hole at the
end of the Axle and bend each end of pin
in opposite directions to secure Wheel.
13. Repeat steps 11 and 12 to secure the other Wheel.