Franklin Fueling Systems GUARDIAN SPGC-220., Руководство по установке

Страница: 9 / 36

5
Installation
Installation instructions
Grounding Terminals
RS485 Communication Terminals
M1 & M2 to STP
L1 & L2 Incoming Power Supply Terminals
200-250VAC, 50/60 Hz, Single Phase
Incoming Dispenser Hook Terminals
(120-240VAC, 50/60Hz, Single Phase)
SW1 Option Select Switch
SW2 Option Select Switch
Reset Button
User Interface Display
Silence/Calibrate Button
Rotary Switch (Future)
SW3 (Future)
(+ / A , G / GND , - / B)
NOTE TO INSTALLER: When the installation is complete, make sure you leave this manual with
the service station owner.
NOTE TO STATION OWNER: Save these instructions for future use, and make sure you provide
them to anyone who services this equipment.
NOTE: Wiring diagrams are in the "Troubleshooting" chapter of this manual.
1. Install the STP according to its installation documentation.
IMPORTANT: The unit can be damaged if you turn on the power when the motor leads are
shorted together or to ground.
2. Use an ohmmeter to verify that the motor leads (M1 and M2) are not shorted to ground.
3. Remove the cover, and install the base on a wall or other flat surface.
NOTE: You must install the SPGC-220 indoors. It can operate at an ambient temperature of
41 – 1040 F (5 – 400 C).
4. Connect the 200-250 VAC input power to L1 and L2, and connect the ground wire to the
terminals as shown in the "SPGC-220 Stand Alone wiring diagram." Do not apply input
power until you are instructed to do so.