For overflow or dishwasher connections, complete the
following procedure. Alternatively go on to section 3.
1
Using a blunt instrument (steel punch or wooden dowel),
knock out entire plug (see 1A). Do not use a screwdriver or
sharp instrument. (When knockout plug falls into Disposer,
you may remove it or grind it up when the disposer is used.
This will not damage the disposer in any way, but may take
some time to grind over the course of several uses).
2
Connect dishwasher hose (see 1B) using a hose clamp.
Make sure all plumbing connections are tight and in accordance
with all plumbing codes and ordinances. Run water and check
for leaks.
1. OVERFLOW/APPLIANCE CONNECTIONS
KNOCK
OUT PLUG
2A
WOOD OR
METAL DOWEL
2B
RUBBER
HOSE
DISHWASHER
HOSE
*
AIR GAP
*Air gap may not be required
for all installations. Check local
plumbing codes.
DRAIN
DISPOSER
1A
1B
WhEN yOu DO NOT WISh TO uTILISE ThE AIR SWITCh
(e.g. if hard wiring the WDu to a standard electrical switch)
Follow the following procedure:
1
With the disposer mounted on the sink and the unit connected
to the mains, turn ON the wall mounted switch.
2
Connect the air switch tube to the nipple on the underside
of the unit.
3
If the disposer is OFF, depress air switch actuator to
turn the disposer ON.
4
With the disposer ON pull air switch hose from disposer
connection and discard air switch actuator and hose.
5
Turn the disposer OFF by turning off the switch, usually
controlled by a wall mounted switch.
6
Operation of disposer is now controlled in a typical manner
by the wall mounted switch.
FRANkE TuRBO PLuS mODELS
TP-50
Continuous Feed
TP-75
Continuous Feed
TP-125
Continuous Feed
TP-125B
Batch Feed
136
356
193
270
295
218
381
136
330
253
416
136
330
253
491
136
