Franke TG925BVY, Руководство пользователя

Страница: 7 / 25

Chapter 1 Ready, set up, go 7
INSTALLATION INSTRUCTIONS
Check the appliance for damage after unpacking it, and don’t connect the appliance if it has been
damaged in transport.
Ensure there is adequate air flow around the rear of the microwave and there is a gap between the
microwave and kitchen unit.
INSTALLATION AND CONNECTION
1. This appliance has been designed exclusively for domestic use.
2. The oven in question has been designed as an integrated appliance.
3. Observe the special installation instructions.
4. The appliance can be installed in a wall-mounted cupboard in heat-resistant material, with a width
of 60 cm (at least 55 cm deep and at least 85 cm from the floor).
5. The appliance is fitted with a plug and simply needs to be connected to a suitably installed socket,
which in turn must be earthed.
6. The mains voltage must correspond to the voltage specified on the appliance rating plate.
7. Socket installation and power cord replacement procedures must be carried out exclusively
by a specialised electrician. If, after installation, the plug is no longer accessible, fit an
omnipolar disconnect switch with a contact opening gap of at least 3 mm in accordance with
the wiring rules.
8. Use of adapters, multi-socket power strips and extension cables is prohibited. Any current
overloads could, in fact, cause a fire.
a a
CENTER LINE
FRONT EDGE
LEFT EDGE
T EDG
E
R
IG
H
A x 2
B x 2
a
a
b
b
C x 10
Acccessible surfaces can
become very hot during use.