6
ZMI
_001_
2000
1051
15
-PR
T
R000
3_#S
EN_#A
QU_#V
1.
fm
10. Assembly Instructions
Warning!
Use the fitting only with non-return valves and the grit filters specified.
Failure to observe can result in an increased bacterial load in drinking water and
cause a health risk or even risk of death.
☞
Important!
Before installing, flush the pipes in compliance with DIN 1988.
☞
Do not shorten the connector hoses located at the fitting.
☞
Only use a 6 V lithium battery type CRP2 as a power supply.
10.1
Install the fitting (a) on the washbasin (b).
☞
Important!
Observe the range settings when installing on a stainless steel washbasin
☞
The corner valves (c) must be provided by the customer.
10.2
Screw the connecting hose (d) on to the corner valve.
11. Function
11.1
Allow your hand to approach the sensor.
• Water flows.
11.2
Remove your hand from the sensor.
• Water flow stops automatically after a set flow duration.
☞
The range of the sensor and the flow duration can be adjusted with the optional
remote control (FAR Order No. 2000101087).
☞
Important!
Reflecting surfaces can influence the sensor. There is a risk of having permanent
reflections (see
for adjusting the sensor range).
“Auto-flush” function
Caution!
When the “Auto flush” function is used, the flow of water must be ensured.
• The "Auto-flush" function ensures that forced flushing takes place to exchange the
water in the tap lines after 24 or 72 hours of non-use.
• The “Auto-flush” function can only be switched on with the optional remote control
(FAR Order No. 2000101087).
• This function is switched off at the factory.
[email protected] - www.hygiene-shop.eu
