Chapter 1
Ready, set up, go
18
WARNING:
• Improper connection of the equipment earthing conductor can result in the risk of an electric shock.
• Check with a qualified electrician or service representative if you are in doubt whether the appliance is
properly earthed.
• Do not modify the plug provided with the appliance. If the plug does not fit properly to the outlet, please have
a qualified electrician to install a proper outlet.
How to Connect the safety supply hose
The appliance must be connected to the water mains using new hose-sets. The old
hose-sets should not be reused.
Water pressure must be between 0,04 MPa and 1 MPa. If the pressure is below the
minimum consult our Service Department for advice.
1. Pull the saftery supply hoses completely out from the storage compartment
located at read of dishwasher.
2. Tighter the screws of the safety supply hose to the faucet with thread 3/4inch.
3. Turn water fully on before starting the dishwasher.
ABOUT THE SAFETY SUPPLY HOSE.
The safety supply hose consists of the double walls. The hose’s system guarantees its intervention by blocking the
flow of water in case of the supply hose breaking and when the air space between the supply hose itself and the
outer corrugated hose is full of water.
WARNING:
A hose that attaches to a sink spray can burst if it is installed on the same water line as the dishwasher. If your
sink has one, it is recommended thet the hose be disconnected and the hole plugged.
How to Disconnect the safety supply hose
1. Turn off the water.
2. Release the water pressure by depressing the pressure release button. This relieves water pressure and
protects you, and the room, from severe splashing.
3. Unscrew The safety supply hose from the faucet..
COLD WATER CONNECTION
Connect the cold water supply hose to a threaded 3/4(inch) connector and make sure that it is fastened tightly in
place. If the water pipes are new or have not been used for an extended period of time, let the water run to make
sure that the water is clear and free of impurities. If this precaution is not taken, there is a risk that the water inlet
can get blocked and damage the appliance.
Drain Hose Connection
Insert the drain hose into a drain pipe with a minimum diameter of 40mm, or let it run into the sink, making sure
to avoid bending or crimping it. The top of the hose must be less than 1000mm.
A
Counter
Front
Drainp ipe
NOTE
Thetop ofthehose
mu stbelessthan
1000mm .
40mm
B
