Franke F7E07S1, Инструкция по установке, обслуживанию и эксплуатации

Страница: 34 / 35

34
REPLACING THE OVEN LIGHTS
WARNING! Disconnect power before servicing unit.
To replace the oven light bulb, remove the protection cap. It is not necessary to
remove the rack supports.
NOTE: Touching the bulb with fingers may cause the bulb to burn out. Always use
protective gloves or use a cloth to remove the bulb.
TROUBLESHOOTING GUIDE
OVEN PROBLEM POSSIBLE CAUSES AND/OR REMEDY
Oven does not function Range is not connected to electrical power. Ask a professional to
check power circuit breaker, wiring and fuses.
Self-clean cycle does not activate Door is not shut tight and door latch cannot lock
Door does not open Oven is still in self-clean mode. Door latch will release when safe
temperature is reached.
Oven light does not work Light bulb is burned out.
Oven is not connected to power.
Clean cycle is on.
Oven door is locked and will not
release after cooling Turn the oven off at the circuit breaker and wait 5 minutes. Turn
breaker back on. The oven should reset itself and will be operable.
Oven is not heating
Check the circuit breaker or fuse box to your house.
Make sure there is proper electrical power to the oven.
Make sure the oven temperature has been selected.
Oven light is not working properly Replace or reinsert the light bulb if loose or defective.
Oven light stays on Check for obstruction in oven door. Check to see if hinge is bent.
Cannot remove light cover
There may be debris/spillage around the lens cover. Wipe lens cover
area with a clean dry towel prior to attempting to remove the lens
cover.
Specific error messages may appear in case of malfunction. Call after sale service and provide the
information that appear in the display for a quick and accurate diagnosis.