Franke ARTH101, Инструкция по установке и эксплуатации, Страница: 6 / 20

6
18
-05
.6
3
3
b
-G
B.f
m
☞
Important!
• Install the height adjuster vertically on a flat wall surface. Use spacers to compensate
for any uneven wall surfaces (see Accessories, Chapter 15 ).
• Protect the height adjuster against drill dust.
Failure to observe can cause the height adjuster to work improperly, for example the
guide block may jam.
☞
The recommended distance from the floor to the lower edge of the height adjuster is
1,200 mm.
☞
For on-wall installations, the wall mounts have cable openings in the frontal side.
☞
The recommended distance from the floor to the exit-point of the connecting lines in the
upper wall mount (a) is 2,350 mm.
9.1
Mark the holes (b) for the wall mounts (a, e).
9.2
Drill according to the markings. Insert the dowels.
9.3
Use a 3-core-electric cable to provide a permanent electric connection.
9.4
Connect the connecting line to the terminal in the upper wall mount (a).
Option:
Guide the connecting line out from the lower wall mount.
☞
If the existing building situation requires, the electric line can also be guided out from
the wall in the lower wall mount (e).
☞
The recommended distance from the floor to the exit-point of the connecting lines in the
lower wall mount (e) is 1,250 mm.
9.5
Install a connecting line from the terminal in the upper wall mount (a) through the
duct (d) to the lower wall mount (e).
9.6
Use a terminal (not included) to connect the connecting line to the electric line in the
lower wall mount (e).
9.7
Use the screws and washers to fasten the height adjuster to the fastening points (b) on
the wall mount.
Caution!
To avoid scratches, use a rubber hammer when driving the covers into the fastening
points.
9.8 Drive the covers into the fastening points so that they are flush with the surface.