Hood body mounting
Firstly, it is necessary to adjust the two Vr-screws of the 11a-
brackets, at minimun (B).
• Hang the hood body on the two brackets 11a.
• Connect the hood to the mains supply by means of a bipolar switch
with at least 3 mm contact gap.
• Press the “A”-key for one second (see Part USE) to open the upper
panel.
• Remove the metal filters.
• In order to align the hood it is necessary to adjust the Vr-screws
from inside the hood.
• Fasten the safety screw 11.
• Fit again the metal filters into their seats and close the upper panel
by pressing “L”-key for one second (see Part USE).
• Disconnect the hood from the mains supply. Attention: the upper
panel stops if any barrier occurs in its way during the panel opening
or closing.
To open the panel it is enough to remove the barrier and press the
key once again.
6