Franke 5526 11 24-F, Инструкция по установке и эксплуатации

Страница: 9 / 60

9
18
-05.
306
e_GB
.f
m
15. Adjusting the Flush-Volume
15.1 Remove the cover plate.
15.2 Set the flow volume regulator to "fully opened" (see Chapter 11.7 ).
15.3 Disconnect the mains voltage supply for min. 60 seconds. The flush-volume setting
is activated.
15.4 Reconnect the voltage supply.
15.5 Wait for the confirmation flashing (1x long 3x short).
15.6 Hook in the cover plate.
15.7 Hold your hand a distance of 5-10 cm in front of the sensor. The LED flashes quickly.
15.8 After 5 seconds the indicator lamp automatically turns off.
15.9 Move your hand out of the sensor-detection area (at least 60 cm away).
15.10 Hold your hand a distance of 5 - 10 cm in front of the sensor. The LED flashes.
2 flashes, pause, 3 flashes, pause, 4 flashes, etc.
15.11 Move your hand out of the sensor-detection area (min. 60 cm) after the required
flash sequence is seen. After this, the fitting flushes with the set flush-volume. After
flushing, the flash sequence of the corresponding flush-volume is displayed.
P: Pause
15.12 Low flush-volume
15.13 High flush-volume.
Flush-volume OK:
15.14 Wait 20 seconds outside of the sensor-detection area (the fitting switches
automatically to the normal operating mode).
15.15 Fasten the cover plate (see Chapter 13.14 ).
Flush-volume NOK:
15.16 Hold your hand a distance of 5 - 10 cm in front of the sensor. The LED flashes.
2 flashes, pause, 3 flashes, pause, 4 flashes, etc.
16. Adjusting the Flush Flow-rate
16.1 Remove the cover plate (see Chapter 15.1 ).
16.2 Adjust the flush flow-rate.
+ Increase flush flow-rate
– Decrease flush flow-rate
16.3 Fasten the cover plate (see Chapter 13.14 ).