EN
– 7 –
FH CR 301 1TC / FH CR 302 2G / FH CR 604 4G /
FH CR 755 4G TC / FH CR 905 4G TC / FH CR 1204 3G TC
To avoid damaging the appliance
X
Z
In the case of thermal failure, switch the
solid plate off and allow to cool down
completely.
X
Z
Do not put any dishes on it. Do not cool with
cold water under any circumstances.
X
Z
Do not climb onto the appliance.
X
Z
Do not leave the appliance unattended
during operation.
X
Z
If the appliance has a lid, make sure the
burners are cold before closing it.
The hob is an item for daily use: signs of usage
such as scratches or visible material abrasion
from pots or cookware are normal. Intensive
use leads to more distinctive signs of usage.
In such cases, the appliance continues to
function perfectly and a complaint is not
justified. Safety is always guaranteed.
X
Z
Maintenance and cleaning
X
Z
Before any cleaning or maintenance
operations disconnect the appliance from
the mains power supply.
X
Z
Do not use steam cleaners or direct jets of
water.
X
Z
Never use scouring pads, steel wool,
muriatic acid or other products which could
scratch or mark the surface.
X
Z
Do not use products containing sands,
alkalis, acids, chlorides, oven sprays
or detergents normally used to clean
dishwashers.
X
Z
Never use sharp objects, as they could
damage the seals between the trim and
worktop.
X
Z
Do not leave acid or alkaline substances on
the hob.
X
Z
Always thoroughly dry the appliance after
going over it with a damp cloth to prevent
scale deposits from forming.
X
Z
Remove grime with a damp cloth.
X
Z
Do not clean the grates, burner caps and
flame-spreaders in the dishwasher. Clean
them with hot soapy water, making sure to
carefully dry them.
X
Z
Ensure the gas outlet zones are perfectly
clean.
Risk of electric shock due to
entering liquid!
The device contains electrical components.
X
Z
Make sure that no liquid enters the interior
of the device.
X
Z
Do not use pressurised steam to clean the
device.
Repair
The appliance is manufactured in compliance
with the relevant effective safety standards.
X
Z
Do not allow anyone except qualified
personnel to install or repair the appliance.
X
Z
Contact a service centre authorised by the
manufacturer or qualified personnel in the
following cases:
– Immediately after unpacking, in the event of
doubts regarding the integrity of the device
– During installation (according to the
manufacturer‘s instructions)
– Doubts regarding the correct operation of
the device
– Malfunction or poor operation
– Replacing the power socket if incompatible
with the power plug of the device
– If the supply cord is damaged, it must be
replaced by the manufacturer, its service
agent or similarly qualified persons in order
to avoid a hazard.
X
Z
Use original spare parts only.
Taking out of service
X
Z
If the appliance is no longer to be used, call
the service centre or qualified personnel to
disconnect it from the power supply.
