Francotyp-Postalia FlexiScale, Руководство по эксплуатации

Страница: 5 / 24

5
Section 2. Installing the FlexiScale
2.1 Unpacking the FlexiScale
Your package includes the following parts:
• FlexiScale
• Weighing platter
• Operator’s manual
• AC Adaptor
• Interface cable
2.2 Setting up the FlexiScale
After unpacking the scale, a small amount of preparation is required before the
scale can be used for mailing or shipping. Refer to the diagram below as needed.
Step 1. Remove the platter protection.
Remove the plastic platter by lifting up on it. Then, remove the cardboard
protector that is situated between the four legs of the platter. Place the
platter on top of the scale and move it around until the four legs of the
platter line up with the four holes in the top of the scale. When the legs of
the platter are aligned with the holes in the scale, press down on the
platter until it rests firmly in place.
Step 2. Install the postage meter.
If you are using the FlexiScale without an FP postage meter, continue to
Step 3.
Step 3. Locate the interface cable.
After placing the scale in its area of use, locate the interface cable. Con-
nect the small end of the interface cable to the connector on the rear of the
scale. Connect the large end of the interface cable to the connector on the
rear of the meter. Configure the scale for your meter type (See Section 6).
Locate the AC Adapter. Connect the female end of the AC Adapter to the
connector on the back of the scale, then plug the opposing end of the
adapter into an AC outlet.