WARNING
The appliance must be installed in compliance with Current Building Regulations.
Incorrectly installed, this appliance can be dangerous
and possibly cause serious accidents.
The manufacturers responsibility shall be limited to the supply of the equipment.
1. Product information
1.1. Package
1 package : Stove complete. The ceramic coals are
supplied inside the combustion chamber.
1.2. General characteristics
Model . . . . . . . . . . . . . . . . . . . . . .
154 05 08
GAS . . . . . . . . . . . . . . . . . . . . . . .
Natural gas
Type / category . . . . . . . . . . . . . . . . .
G20 / I
2H
Gross calorific value (heat inpout) . . . . . kW
4,3
Nominal output . . . . . . . . . . . . . . . kW
3
Supply pressure . . . . . . . . . . . . . . mbar
20
Burner pressure . . . . . . . . . . . . . . mbar
18,5
Gas rate . . . . . . . . . . . . . . . . . . m
3
/h
0,44
Injector size . . . . . . . . . . . . . . . . bray
18/200
T.T.B. Cut off temperature . . . . . . . . . °C
100
Reset temperature . . . . . . . . . . . . . °C
85
1.3. Description
The Belfort stove has been individually designed to add
traditional charm and character to your home. Providing
a highly efficient heat source, the Belfort has the look
a n d c h a r m o f a ‘ r e a l ’ s t o v e c o u p l e d w i t h t h e
convenience of clean burning gas.
The stove is designed to run both off natural gas
however each individual appliance is only capable of
running off the type of gas specified at the time of
purchase. It is important to note that once a type of gas
has been specified the stove cannot run off any other
type. The type of gas which your stove is capable of
burning is stated on the data information panel (See
Paragraph 3).
1.4. Principle of operation
THERMOSTATIC SWITCH (TTB) : The TTB is a
normally closed bi-metallic switch which is designed to
open at a pre-set temperature (90°C) and reset to the
closed position when the temperature falls to a reset
level (normally 15°C below the operating temperature).
The system is not adjustable, and should not be
rendered inoperative.
If parts of the system require replacement only original
parts must be used.
4 2 0
5 5 0
4 0 9
Ø 1 2 5 i n t .
3 4 0
1 3 1
Product information
Figure 1 - Dimensions in mm
Model 154 05 08
Belfort
Technical manual
3
