Francis Searchlights A7145, Инструкция пользователя и руководство по установке

Страница: 31 / 39

8 - Maintenance and Servicing
In order to prolong the service life and performance of your searchlight, the following
maintenance guidelines are recommended:

Maintenance checks should be conducted before every voyage or at least every three
months;

Before checking, disconnect the equipment from the supply;

Visually inspect the condition of the equipment;

Any major or minor structural damage should be rectified immediately in order to reduce
sympathetic wear;

After inspection it may be necessary to clean the inside of the searchlight. The following
procedure should be adhered to:

Remove the front bezel;

Clean the front glass inside and out using a proprietary glass cleaner;
 Clean the reflector if required;

Ensure that the lampholder is free from corrosion or other damage;
 It is advisable to check all seals and gaskets for signs of degradation. Renew if necessary;

The searchlight is fitted with a breather unit. This ensures a steady airflow in order to
prevent any vacuum forming within the barrel.

Upon completing all maintenance requirements, the searchlight should be tested for full
working order (approximately 20 minutes).
If in any doubt as to the correct servicing procedures to adopt, please contact your
distributor/agent or the manufacturer who will be able to advise the best course of
action for your product.
Notes for Lamp Fitting/Removal for LX300RC 300w Xenon
To fit lamp:

Remove lamp from packaging;

Remove front and rear bezels from searchlight by unfastening the latches;

Screw the lamp into the rear lampholder HT, fit rear black lamp lead and secure with rear
lampholder HT nut;

Place the HT lead (large white lead) over the front of the lamp (positive) and secure in
position using the lamp heatsink;

Now screw the PTFE insulator into the lamp heatsink and ensure that the HT lead is tightly
secured to prevent any arcing;

Place the PTFE bush over the insulator and fix mechanism in position by pushing the
retaining clip through the insulator;

Replace front and rear bezel assemblies and fasten down clips securely, ensuring bezels
are central to barrel and a good seal is achieved;

Reverse this procedure for lamp removal.