Cleaning the Disk Surface
After using the sander, the sandpaper surface can become filled up or “clogged” from
sawdust. You should not replace the disk at this point. Use the included cleaning block
to “clean” the surface.
To do this, simply hold the cleaning block at an angle so
just one edge is touching the sandpaper on the disk plate.
Using very light pressure, slowly turn the disk plate. The
particles clogging the surface should begin to fall off.
Continue this until the particles cease to drop.
You should note that after cleaning, the sandpaper may not look clean, but discoloration
is normal on the surface of the disk where it has been used. The discoloration doesn’t
have to disappear for the “grit” to be clean. The whitish coloring will be trapped in the
backing material, even after a clean surface.
*pictures may vary from actual product
9
© 2017 framingsupplies.com
All Rights Reserved