M A N U A L O S E - C 2 3 0 0 / 2 3 0 1 V 3 . 0
Revision: 2016-07-13
Fraba GmbH
6 / 8
Zeppelinstr. 2, D - 50667 Köln
Tel.: +49 (0) 221 - 9 62 13-0, T49 (0) 221 - 9 62 13-60, www.vitector.de, [email protected]
GB
Terminal assignment/wiring for one or two safety devices
Terminal designation
Function
Power A1, A2
Power supply :
OSE-C 2300: 230 V AC +/- 10%; protection class II (DIN EN 60529)
OSE-C 2301: 24 V DC +/- 20 %
1 BN
12 V – Power supply for the safety devices (brown lead)
2 WE
0 V – Supply for the safety devices (white lead)
4 GN1
Signal transmission for connection of the first safety device (green lead)
5
In case of connection of one safety device: wire bridge to terminal 6
In case of connection of two safety devices: without wire bridge
6 GN2
In case of connection of one safety device: wire bridge to terminal 5
In case of connection of two safety devices: Signal transmission (green) of 2nd safety device
1 BN
2 WE
4 GN1
5
6 GN2
1 BN
2 WE
4 GN1
5
6 GN2
Operating status, fault diagnosis, trouble-shooting (displayed 5 s after power on)
LED display
Operating status
Possible cause
Remedy
Status of safety device 1 connected at terminal 4 is displayed by a slow flashing display
Status of safety device 2 connected at terminal 6 is displayed by a fast flashing display
safety device
OK
low transmission power
not necessary
safety device
sufficient
medium transmission power
not necessary
safety device
bad
maximum transmission power;
maybe rubber profile bad
check assembly and quality of the rubber
profile
safety device
defect
defect;
sensor, cable, permanent actuation
check, maybe change: cabling, sensors,
rubber profil
segments
flashing
failure
rapid shut-down,
maybe the control unit is defect
turn off and on again, maybe change contol
unit OSE-C 2300 / 2301
Indications (at continous operation)
LED display
Operating status
decimal
point
Ready for working
upper
segment
safety device 1 at terminal 4 in function and enabled
lower
segment
safety device 2 at terminal 6 in function and enabled
both
segments
By usage of one safety device at terminal 4 both segments are displaying the function of this safety device
(wire bridge from terminal 5 to 6!).
