Maintenance
Other factors outside the tool may cause loss of power or erratic action. Reduced compressor output, excessive drain on the air line, moisture or restriction in
air pipes or the use of hose connections of improper size or poor condition may reduce air supply. Grit or gum deposits in the tool may cut power and may be
corrected by cleaning the air strainer and flushing out the tool with gum solvent oil or an equal mixture of SAE#10 oil and kerosene. If outside conditions are
in order and tool is out-of-warranty, disconnect tool from hose, disassemble tool, replace worm or damaged parts, clean, reassemble, and re-lubricate, or take
tool to any air tool service center. For tools in warranty period, send tool direct to Warranty Center.
Lubrication
Ensure the air line is shut-off and drained of air before removing this tool for service or changing sockets. This will prevent the tool from operating if the
throttle is accidentally engaged.
An in-line filter-regulator-lubricator is recommended as it increases tool life and keeps the tool in sustained operation.
Regularly check and fill the in-line lubricator with air tool oil. Avoid using excessive amounts of oil.
Adjust the in-line lubricator by placing a sheet of paper next to the tool's exhaust ports and holding the throttle open approximately 30 seconds. The lubricator
is properly set when a light stain of oil collects on the paper.
If it is necessary to store the tool for an extended period of time (overnight, weekend, etc.), generously lubricate the tool through the air inlet. Run the tool for
approximately 30 seconds to ensure the oil is evenly distributed throughout the tool. Store the tool in a clean and dry environment.
Recommended lubricants: Air tool oil or any other high grade turbine oil containing moisture absorbent, rust inhibitors, metal wetting agents, and an EP
(extreme pressure) additive
WARRINH
Florida Pneumatic Manufacturing Corporation warrants its tools to be free from
defects in materials and workmanship for a period of one year. Tools thought to be
defective should be returned to the factory, or an authorized
service center, transportation charges prepaid, for examination and
consequent repair or replacement. This warranty does not cover
damage to tools arising from alteration, abuse, or use for other
than their intended purpose and does not cover any repairs or
replacement made by anyone other than Florida Pneumatic
Manufacturing Corporation or its authorized repair stations.
The duration of the Warranty and any other Warranty including,
but not limited to, any implied Warranty of merchantability is expressly limited to one
year, beginning from the date of the delivery to the original user. The obligation of
Florida Pneumatic Manufacturing Corporation under any Warranty, express or implied,
is limited solely to the repair or replacement at its factory or authorized repair station of
any part which shall prove defective.
FLORIDA PNBJMATIC MANUFAC1URING CDRURATION
851 JUPITERRi\RKLANEI JUPITER, FL33458
800-327-9403
www.Cbrida-pneumatic.com
