Regency Wood Insert & Hearth Heater
9
INSTALLATION
Diagram 4:
H2100M and I3100L
Faceplate Assembly
B) H2100M and I3100L Insert
Diagram 2: I1100S
Rear View
Diagram 3: I1100S
1)
Slide the spring nuts (supplied) over the
slots in the insert’s side convection panels
(the spring nuts may need to be squeezed
with a pair of pliers fi rst, to help them stay
in position).
2)
Screw the side faceplate panels, (item A in
Diagram 4) one to each side.
3)
Using the top panel (item B in the diagram)
as a gauge, check that the side panels are
within approximately 1/4" of the overall width.
If the difference is greater than this, use
the supplied washers to attain the required
width.
C) All units
The unit may now be slid into fi nal position and
attached to the connection system.
Once connection is made, the insulation strips
should be installed between the insert faceplates
and the fi replace face. The faceplate top may
now be installed (with insulation strip behind)
by aligning its brackets with the top fl ange on
the side shields and the angle iron bar on the
insert top. The faceplate trim may be installed
to the edge of the faceplate at this time.
I1100S:
Drill two 5/32" diameter holes through
the trim and side panels and screw the trim to the
panels using the gold plated screws provided.
Note: It may be easier to install the insula-
tion, faceplate top and faceplate trim
with the unit pulled slightly away from
the fi replace face. If this is done, be
very careful not to disturb the con-
nector when shifting the unit to its
fi nal position.
Now that your insert is installed, check once
more that all the clearances from the unit to
any combustible materials are correct as listed
earlier.
Diagram 1: I1100S
6)
Once the above items have been checked,
slide your insert into position after fi rst po-
sitioning the fl ue liner and offset if required.
(Re-install raincap at completion of installa-
tion).
FACEPLATE AND TRIM
Prior to sliding your insert into its fi nal position
and attaching the connector or liner pipe, the
faceplate side panel plates must be installed
as follows:
A) I1100S Small Insert
1)
Fasten the faceplate mounting bracket to the
side of the insert (one on each side) using
the screws provided (2 screws per bracket)
(refer to Diagram 1).
2)
Assemble the faceplate sides and top with
4 screws (see Diagram 2).
3)
Attach the assembled faceplate to the
faceplate mounting brackets.
Flush Inserts
Hearth Heater
4)
If the fl oor of your fi replace is below the
level of the fi replace opening, adjust the
insert's levelling bolts to accommodate the
difference. When additional shimming is
required, use non-combustible masonry or
steel shims.
5)
Measure approximately the alignment of
the fl ue liner with the position of the smoke
outlet hole on the insert to check for pos-
sible offset. If an offset is required, use a
proper stainless steel unit available with
the chimney liner.
