Page 4
HCF/HCC
© 2022 FP Mailing Solutions
Step 14 -
On the HCF control panel.
The main power switch is on the right.
The left switch gives power to the motors
The Ready button starts the envelopes down the
Registration board and starts looking at the sensors.
Adjust the speed settings to the standard setting of 3 for
Com 10. You can adjust from there to a faster speed for
longer media and a slower speed for shorter media
Step 13 -
Adjust the hopper guides to size of media you are feeding. Use the hopper guide
knob to adjust the guides
(note the lock down knob on the operator side of the feeder.)
The registration board guides can be moved by hand. You want them close to the media
at the bottom but loose at the top because of the funnel shape of the guides.
Step 15 -
The separator adjustment knob might need to adjusted tighter or looser
depending on how the media is coming out of the hooper guides. If it is pulling doubles
you need to adjust tighter or adjust looser if the media is not feeding at all.
Step 12 -
In the printers menu, two settings need to be change to facilitate the feeders
operation.
MENU -> MENUS -> PRINT ADJUST -> NARROW PAPER SPEED = Normal 2
MENU -> CALIBRATION -> SPECIFIC MEDIA FEED MODE -> MP-TRAY - > 2
