Registration
This products require registration between the transmitter and receiver, in order
to establish a wireless link. The registration process includes keys exchange, for
enhanced security and can be managed using the remote control, provided with the
product.
Sets of the transmitter and the receiver usually arrive pre-paired, when purchased
as pairs. In such case, video link will be established automatically after completing
installation.
The registration is required only once, and after registration, the sets of transmitters
and receivers will connect automatically upon boot up.
Registration using a remote control
The transmitter has the ability to connect up to 4 receivers at a time. During registration
power down any pre-registered receiver to prevent any video transmission during the
registration process.
1. Connect the HD Source to the transmitter (the registration process can be
done without HD source in which case an OSD message will appear to notify
of missing video source).
2. Using HDMI cable connect receiver intended for registration to a HD display.
3. Power on the transmitter and receiver.
4. Press the “
Add
”
Hotkey button on receiver remote control.
5. The message “
Please Activate Registration on Transmitter Unit
” will
appear on the monitor.
6. Press the registration button on the transmitter side until the “
Network
” LED
starts blinking.
7. Wait for the OSD message "
Adding
[
Tx name
]
Press OK to continue or
Exit to cancel
".
8. Press the “OK” button on the IR Remote to confirm the addition of the
receiver.
9. Wait until the registration process is complete. An OSD message of "
Adding
[
Tx name
]
…
"and progress bar will appear during the process.
10. Video link is now established.
