FOXTECH AYK-250
User Manual
©
2021 FOXTECH All Rights Reserved
13
Test Flight
Before the first flight, it’s suggest to check if every component is well connected, Servos working
properly, motors spinning to the correct direction and all control surfaces are moving to the desired
directions.
It’s suggested to use 3 modes, Cruise, Qhover and Qloiter as the labled modes on a three position
switch. It’s suggested to do the first flight in a very open area with no buildings or big trees around,
and a flat taking off area is necessary.
Use the Qhover(or Qloiter) mode, start the motors by pushing the rudder all to the right with the
throttle at the lowest position, the motors should start to spin, gradually increase the throttle until
the plane is ready to lift from the ground, move aileron, elevator and rudder stick gently to check if
the plane is moving as desired.
Continue to push the throttle until the plane is lifted from ground, it may swing a bit since there
should be big airflow hitting the wing, lift the plane to around 3 meters and try to fly it as a multi-
copter, it should not be a problem for anyone who can play a multi-copter.
When you are familiar with all controls, lift the plane to at least 50m from the ground and make sure
there is not obstacle in front of the plane.
Switch it to Cruise mode, the AYK-250 VTOL rear motor should work, once the speed is reaching at
least 16m/s, the multi-copter motors will stop spinning, then the AYK-250 is now transferred to fixed
wing.
It’s also suggested to active the short and long failsafe, the default action is respectively CIRCLE
and RTH. So in case the plane lose RC control, it will go back all by itself.
You can fly a while and see if the plane could go straight, if you find the plane is tilting left for
example, don’t try to trim the aileron with your radio, the trim to aileron(SERVO1) must be done in
parameter setting. (If the elevator trim is necessary, please trim the SERVO2 and SERVO4 at the
same time with the same trim amount.)
GCS FAILSAFE disabled as default setting for DA16(S+) radio or the control range will be greatly
affected.
Содержание AYK-250 VTOL
Страница 1: ...User Manual V1 0 FOXTECH AYK 250 VTOL 2021 11...
Страница 6: ...FOXTECH AYK 250 User Manual 2021 FOXTECH All Rights Reserved 5...
Страница 10: ...FOXTECH AYK 250 User Manual 2021 FOXTECH All Rights Reserved 9...
Страница 11: ...FOXTECH AYK 250 User Manual 2021 FOXTECH All Rights Reserved 10 4 Check Flight Modes Cruise QHover QLoiter...