6
3.
Slide the battery compartment door back on the TX35.
2.
Operating Instructions
This section covers all sound playback and general operation instructions of the Cabela’s SL
P
Game Call,
TX35 remote control, and FOXJACK 4 Decoy.
2-1
Playing Sounds
Before using the Cabela’s SL
P
Game Call and TX35 remote control, make sure that both devices have good
batteries installed.
1.
Turn on the game call by turning the power switch clockwise to the ‘on’ position. The green LED
will illuminate indicating the power is turned on.
2.
Verify that at least one of the speaker selector switches is in the ‘on’ position.
3.
Turn on the TX35 remote control by pushing and holding the send/power button for 1 second.
The display will activate and display “SELECT SOUND”.
4.
Cycle through the sound list by using the sound selector buttons. Each button press steps
through the list one sound at a time. When you find a sound that you wish to play, push the
send/power button a single time.
5.
In order to hear the sound, you must increase the volume level. You can press the volume up
button to increase the volume. The available volume level spans from 0 – 20. By default, the
volume is inaudible when you first turn it on.
6.
If you wish to mute the sound, push the mute button a single time. To resume playback, push
mute a second time.
7.
To switch sounds, repeat step number 4.
8.
To turn off the game call: move the power switch to the ‘off’ position. To turn off the TX35: push
and hold the power/send button for about 4-5 seconds and then release (a message “TURNING
OFF” should briefly appear).
Turning off the TX35 remote control does not result in termination
of sound playback on the game call.
You can mute the game call first (see step 6) prior to
powering down, otherwise it will continue playing the sound.
2-2
Using the FOXJACK 4 Decoy
The Cabela’s SL
P
Game Call features the
FOXJACK 4 Decoy mounted to the back
side of the housing. This section explores
the setup and operation of the FOXJACK 4
Decoy.
FOXJACK 4 General Setup:
1.
Check that the FOXJACK 4
Decoy is properly connected to
the wiring harness inside the
battery compartment of the
predator call by removing the
FOXJACK 4 (see image to the right). The FOXJACK 4 is secured to the back of the predator call
with a knurled thumbscrew. Turn the thumbscrew counterclockwise to loosen and then lift up
the front of the FOXJACK 4 to gain access inside. Notice that there is a wire leading from the
FOXJACK 4 and connecting to a wiring harness located inside the battery compartment. If the
Содержание Cabela's SLP Predator Call
Страница 1: ......
