19
Section 2.1 Assemble the Sensor
7.
After tightening the membrane cap, slide the vent seal up into the groove, so
that it covers the vent hole. Rub around the vent seal to remove any bubbles
or voids.
If liquid leaks through the membrane, the membrane is faulty and
you must use a new membrane cap.
8.
Take the stepped collar, smaller diameter up, and insert a screwdriver into
the split to enlarge the opening.
9.
Push the stepped collar down until it snaps into position in the sensor shaft
groove.
10.
Slide compression ring and O-ring onto the sensor shaft in the order shown.
11.
Push the ring and O-ring up against the stepped collar.
