3
29
Advanced Chipset Features
► Memory Configuration/DRAM Timing Configuration
Press <Enter> to go to its submenu.
► CAS Latency
This item shows the CAS latency. The CAS Latency is the number of clock cycles that elapse
from the time the request for data is sent to the actual memory location until the data is
transmitted from the module.
► RAS/CAS Delay
This item displays a delay time (in clock cycles) between the CAS and RAS strobe signals.
► Row Precharge Time
This item shows the number of clock cycles taken between issuing of the precharge command
and the active command. The DRAM row precharge time is in unit of clock cycle.
► Min Active RAS
Displays the number of clock cycles taken between a bank active command and issuing of the
precharge command.
► RAS/RAS Delay
This item
displays a delay time (in clock cycles) between the RAS and RAS strobe signals.
► Row Cycle
This item shows the minimum timing interval between successive active commands to the
same bank. The row cycle time is in unit of clock cycle.
► Internal Graphics Mode
Enable/Disable the integrated UMA graphics controller.
► GFX Engine Clock
It allows you to change the clock rate of graphics engine.
► Surround View
SurroundView is the ATI technology that provides multi-graphics controller display capability
for both the ATI PCIe-based graphics card and the ATI integrated graphics processor (IGP).
Enabling SurroundView does not impact display modes (resolution and color depth) or
performance. The display mode of each output is controlled independently by the graphics
controller connected to it.
CMOS Setup Utility - Copyright (C) 1985-2006, American Megatrends, Inc.
Advanced Chipset Features
NorthBridge Chipset Configuration
Help Item
► Memory Configuration
[Press Enter]
► DRAM Timing Configuration
[Press Enter]
CAS Latency
:6 CLK, N/A
RAS/CAS Delay
:6 CLK, N/A
Row Precharge Time
:6 CLK, N/A
Min Active RAS
:15 CLK, N/A
RAS/RAS Delay
:4 CLK, N/A
Row Cycle
:21 CLK, N/A
Internal Graphics Configuration
Internal Graphics Mode
[Enabled]
GFX Engine Clock
[400]
Surround View
[Disabled]
↑↓←→:Move Enter:Select +/-/:Value F10:Save ESC:Exit F1:General Help
F9:Optimized Defaults
[Press Enter]
