Foxconn A74GA Series, Руководство пользователя

Страница: 37 / 56

3
30
Power-On Self-Test (POST). The LED is located at the front panel, and it displays POST state
by different long-short blinking intervals. You can always leave this state enabled.
► Smart Boot Menu
When PC starts, it will ask you to press [Del] key to enter setup or press [Esc] key to enter
smart boot menu. If [Disabled] is selected, then pressing [Esc] has no function.
Fox Intelligent Stepping
► CPU Clock
This option is used to adjust the CPU clock.
► CPU Multiplier Adjust (Optional only if CPU supports)
This option is used to adjust the CPU Clock Ratio. Multiply CPU clock with this ratio, you can
get the CPU speed. Increase this ratio may overclock your CPU. This option will be displayed
only if your CPU is supporting this feature.
► CPU-NB HT Link Speed
HT stands for HyperTransport bus. The CPU<->NB HT Speed option controls the physical
speed of the CPU to Northbridge HT link. The physical speed of the link is determined by
multiplying the CPU clock with the CPU<->NB HT Speed setting.
► Memory Speed Mode
This item is used to enable/disable provision of DRAM timing by SPD device. The Serial
Presence Detect (SPD) device is a small EEPROM chip, mounted on a DDR3 memory
module. It contains important information about the module's speed, size, addressing mode
System Status Power LED Status
Normal On
No CPU Fan Blinking once (blinking 0.5 sec., off 0.5 sec.)
No Display Blinking once (blinking 2 sec., off 2 sec.)
No Memory Blinking twice
Post Error Message Blinking thrice
CMOS Setup Utility - Copyright (C) 1985-2006, American Megatrends, Inc.
Fox Intelligent Stepping
CPU Clock [200] Help Item
Current CPU Speed : 2800MHz, NB CLK: 2000
CPU Multiplier Adjust [Auto]
CPU-NB HT Link Speed [Auto]
Current FSB/HTT Speed : 1000MHz
Memory Speed Mode [Auto]
Current DRAM Speed : N/A, 1066 MHz,
PCI Express Clock [100]
Spread Spectrum [Enabled]
Memory Voltage Control [Disabled]
DRAM Voltage : 1.584 V
NB Voltage Control [1.2V]
↑↓←→:Move Enter:Select +/-/:Value F10:Save ESC:Exit F1:General Help
F9:Optimized Defaults
[200]