fox fury RUGO, Руководство по эксплуатации продукта

Страница: 4 / 8

6
7
REASSEMBLING THE RUGO
™
AFTER CHARGING
1. Install the Power Pack to the Light Head—confirm position of alignment
posts to their respected cavities.
2. Push both halves together. A ‘click’ should be heard as they become
locked together.
Test the light to make sure that the Power Pack is properly connected
to the Light Head by pressing the Power/Mode Switch.
POWER PACK LIFE
MODE DURATION LUMENS
HIGH 1hr 700
MEDIUM 1.5hrs 400
LOW 3.5hrs 200
DIM 6.75hrs 70
*Power Pack life may vary according to age and ambient conditions.
OPERATIONAL MODES
ON/DIM mode: Press the Power/Mode Switch once.
LOW mode: From DIM mode, press the Power/Mode Switch once.
MEDIUM mode: From LOW mode, press the Power/Mode Switch once.
HIGH mode: From MEDIUM mode, press and hold the Power/Mode
Switch once.
OFF: From ANY mode, press and hold the Power/Mode Switch for 2 sec.
LOW POWER INDICATOR: At a low level, the Charge Indicator will flash
for approximately 0.5–1.0 sec. It is suggested that you then charge or
replace the Power Pack with a fully charged one. If on a higher mode and
you need to continue using the light, it is suggested that you adjust the
mode to a lower setting.
NOTE: The light does not retain the mode in memory. Once you turn the light
ON, you will have to re-select the mode you desire.
USING THE TRI-LENS
™
AREA
55°
BEAM DISTANCE : 30ft (10m)
USED FOR: Mid-range
FLOOD
120°
BEAM DISTANCE : 10ft (3m)
USED FOR: Close-up
SPOT
BEAM DISTANCE : 100ft (30m)
USED FOR: Distance
18°
The Rugo
™
Tri-Lens
™
has three (3) beam emission angles which can be used for
many different applications by simply sliding from left to right and vise-versa.
1. Push the Tri-Lens ™ to either the right or left side until it won’t go any
further. Use your fingers to slightly pull the Guards away from the unit,
while pushing the Tri-Lens
™ with your thumb. This will help the Tri-Lens ™ to
overcome the ridge, (located at the end of the Guard) and will allow it to
be easily released.
2. Once the Tri-Lens
™
overcomes the ridge, pull it free from the Light Head.
FOR RE-INSTALLATION: Line up the Tri-Lens
™
with the ridge. Then push it
back into position on the Light Head.
REMOVING THE TRI-LENS
™
1
1
2
2
1
2