Before installing it on the back of the vehicle, make sure that there is a suitable place for
suction foot, and that the bicycle will not block the license plate after installing the bicycle.
21
5. Tie the saddle suction foot to the bicycle saddle, and tie the strap tightly to avoid shaking and loosening during driving.
6. Invert the bicycle to the roof of vehicle, install the bicycle handlebar on the handlebar clamps, and tighten the handlebar straps to firmly bind the bicycle handlebars, as shown in
Figure Ⅴ.Straighten the saddle suction foot, connect the pneumatic hose on the saddle suction foot to the control box, press the saddle suction foot down, then the saddle suction
foot will be automatically attached to the installation surface.
Attention：
1. We recommend that you use a strap to keep your crank arm in place while driving,This will prevent the crank moving in transit.
2. Before driving the vehicle, please ensure that the control box is fully charged, the power switch is kept on, and check whether the bicycle handlebars, saddle , and crank are securely tied.
3. After using the roof rack, remove the bicycle first, then turn off the power switch of the control box, and open it one by one along the edge of the suction foot with your hands, let
the air enter the suction foot, and then take off the roof rack.
4. When not in use store the rack in a clean box and ensure that the suction foots are not damaged or deformed.
Instructions
Installation
Figure Ⅴ
