FOUR MP100BTi, Руководство пользователя

Страница: 16 / 28

1
6
INSTALLATION
Notes:






Choose the mounting location where
the unit will not interfere with the
normal driving function of the driver.
Before finally installing the
unit, connect the wiring temporarily
and make sure it is all
connected up properly and the unit
and the system work properly.
Use only the parts included with the
unit to ensure proper installation. The
use of unauthorized parts can cause
malfunctions.
Consult with your nearest dealer if
installation requires the drilling of
holes or other modifications of the
vehicle.
Install the unit where it does not get in
the driver’s way and cannot injure the
passenger if there is a sudden stop,
like an emergency stop.
If installation angel exceeds 30°from
horizontal, the unit might not give its
optimum performance.
-
Avoid installing the unit where it would
be subject to high temperature, such
as from direct sunlight, or from hot air,
from the heater, or where it would be
subject to dust, dirt or excessive
vibration.
DIN FRONT-MOUNT
Installation Opening
This unit can be installed in any
dashboard having an opening as shown
below:
Installing the unit
Be sure you test all connections first, and
then follow these steps to install the unit.

Make sure the ignition is turned off,
and then disconnect the cable from the
vehicle battery’s negative (-) terminal.

Disconnect the wire harness and the
antenna.

Mount the sleeve by inserting the
sleeve into the opening of the
dashboard and bend open the tabs
located around the sleeve with a
screwdriver. Not all tabs will be able to
make contact, so examine which ones
will be most effective. Bending open
the appropriate tabs behind the
dashboard to secure the sleeve in
place.
Tabs
Screwdriver
Sleeve
Dashboard

Reconnect the wire harness and the
antenna and be careful not to pinch
any wires or cables.

Slide the unit into the sleeve until it
locks into place.

To further secure the unit, use the
supplied metal strap to secure the
back of the unit in place. Use the
supplied hardware (Hex Nut (M5mm)
and Spring Washer) to attach one end
of the strap to the mounting bolt on the
back of the unit. If necessary, bend the
metal strap
to fit your vehicle’s mounting area.
Then use the supplied hardware
(Tapping Screw (5x25mm) and Plain
Washer) to
30
53mm
182mm
16