Four winns S Series, Руководство пользователя

Страница: 89 / 180

Owner’s Manual Page 87 Waste & Water Systems - Section J
Figure J9: Filling Fresh Water Tank
NOTICE
Before each use: With seat cover closed, open
and close the holding tank valve (Figure J9)
to vent any pressure that may have built up
as a result of heat or altitude. This prevents
upward splashing of bowl contents when toilet
is flushed.
Figure J10 (A & B): Porta-Potti - Bellows Flush Operation
Bellows Flush Operation:
1. Pull out holding tank valve handle (Figure J10B).
2. Push down on bellows to rinse the bowl.
3. Push valve handle all the way in to insure an odor-
tight seal.
Emptying of Portable Models:
1. Empty when waste holding tank level appears full.
DO NOT ALLOW THE TANK TO BECOME OVER-
FILLED.
2. Make sure waste valve handle is in the closed posi-
tion.
3. Remove fresh water tank from waste holding tank
(Figure J11).
Figure J11: Removing Fresh Water Tank
B. Porta-Potti
A porta-potti or porta-potti with pumpout is available
on certain SL series models. A general guide on
porta-potti use is included in this section. Note: Mod-
els may vary. Refer to the manufacturer’s literature
included in the owner’s packet regarding the use, care
and maintenance of the porta-potti if installed.
Porta-Potti Preparation:
Separate unit by sliding the locking lever to the left
“unlocked” position and hold (Figure J6A). Separate
the units (Figure J7B).
Figure J7 (A & B): Separate Porta-Potti
With the waste tank (lower section) sitting flat, open
valve by pulling handle out (Figure J8A).
Add deodorant through the valve opening (Figure
J8B). Use Thetford Holding Tank Deodorant (sample
included) in built-in storage compartment (Figure
J8C). Add water to cover tank bottom. Close valve
and replace deodorant (Figure J8D).
Figure J8 (A - D): Porta-Potti Preparation
Recombine the unit. Align hinge with front interlocking
tabs. To secure unit, press downward – it should click
into place.
Fill fresh water tank by removing the water fill cap and
filling the tank with fresh water (Figure J9). (NEVER
add holding tank chemical to the fresh water tank
assembly.) Replace and tighten the cap securely.