OLD SALEM GAS COAL VENT FREE FIREPLACE
Page 14 of 16
4. Wait five minutes to clear out any gas. Then smell for gas, including near the floor. If you
smell gas, STOP! Follow “B” in the safety information above on this page. if you don’t smell
gas, go to the next step.
5.
Push in gas control knob slightly and turn clockwise-) to “Pilot.
6.
Depress the control knob fully and push spark igniter button several times to light the
pilot.
7.
Continue to hold the control knob in for about 60 seconds after the pilot is lit. NOTE: If
the pilot extinguishes, repeat steps 1,2,3 and 4.
8.
Turn the control knob clockwise —) to “ON”.
9.
Adjust the HI-LO flame control knob to desired selling.
NOTE:
*If
the unit is hot, wait 5 minutes to relight the pilot.
*If control knob does not pop up when released STOP, and immediately
call
your service technician or gas supplier.
10.
Replace control access panel below grate.
11. Wall switch or remote may now be used to turn main flame ON and OFF
.
TO TURN OFF GAS TO APPLIANCE
I.
Remove control access panel below grate.
2.
Push in
gas control knob slightly and turn clockwise to “OFF” position. Do not force.
3.
Replace control access panel below grate.
If a remote control
system
is to be used, refer to drawing on Page
5
of
this
manual.
15) CLEANING PROCEDURE
CAUTION: Only the simplest of cleaning such as dusting the cast iron grate and control
mechanism etc. is allowed. The latter must be accomplished by a qualified service person. If
coals become loose contact Four Seasons.
16) GENERAL MAINTENANCE
(a) INSTALLATION AND REPAIRS SHOULD BE DONE BY A QUALIFIED AND
CERTIFIED SERVICE PERSON. IT IS RECOMMENDED THAT THE APPLIANCE BE
INSPECTED BEFORE EACH USE FOR DAMAGE TO THE COALS AND AT LEAST
ONCE A YEAR BY A PROFESSIONAL CERTIFIED SERVICE PERSON. IT IS OF
