SETTING UP
*
1.
Decide on a position for each ingredient cartridge on
the machine
2.
Set the stroke adjusters on the cartridge holders to the
recommended setting (see diagram below.
Recommended settings are shown on the cartridge)
3.
Fit the ingredient cartridges to the machine
4.
Fit the drip tray and drip tray cover
5.
USING THE MACHINE
*
1.
Place an empty cup under the desired ingredient
cartridge
2.
Push rocking mechanism in until it stops, then allow it
to snap back (some drinks will require more than one
push, see cartridge for recommended dose)
3.
Place cup under water outlet and press button until cup
is filled to the desired level.
4.
Stir drink to ensure product is dissolved.
Creamy coffee:
1.
Place an empty cup under the coffee outlet.
2.
Select the button for the desired quantity (large or
small)
LED-indicator
Red blinking: Water warming up
Green: temperature ok
Groen blinking: during coffee/water distribution cycle
Cup volume adjustment
*
Before making any adjustment ensure that the machine is
at operating temperature and green led on
The quantity of coffee for a large or small cup can be set as
follows:
1.power off the machine
2.press and hold both large and small cup button and
power on the machine to enter programming mode
3.release both buttons
4. put a small cup under the coffee outlet
5. push and hold the small coffee button until the desired
quantity is in the cup and release button.
6.repeat step 5 and 6 for the Large cup: push and hold the
button until the desired quantity is in the cup and release
button.
7 power off the machine to store the quantities in memory
and quit programming mode
Quantity in the cup can individually be increased by holding
the button pushed during
Remark: the hot water button cannot be programmed for
a preset quantity. Water will be dispensed as long as the
button is pushed.
SAFETY FEATURES
*
A thermostat controls the water temperature in your
machine. In the unlikely event of failure, a thermal reset
device protects the machine. This will switch off the power
to the heater if the temperature becomes too high.
If the machine suddenly stops heating, it is probable that
this reset has operated. To re-start the machine, please
contact your dealer.
CARE & MAINTENANCE
*
CLEANING
The drip tray should be removed and cleaned at least once
a week.
Stainless steel surfaces can be cleaned with a soft cloth and
proprietary products providing no abrasives are used.
DESCALING
As with any water heating appliance, lime scale will be
produced in hard-water areas. To ensure that your machine
remains efficient it should be descaled at regular intervals.
Your Fountain dealer can carry this out.
If you wish to descale the machine yourself, you will need
descaling crystals and a siphon pump to remove the
treated water from the tank. These items are available
from your Fountain dealer, along with full instructions for
their use.
WARNING
FREEZING
Your machine should not be installed in places where the
temperature could drop below 0° Celsius.
IF YOU THINK THE WATER IS FROZEN, DO NOT SWITCH
ON THE MACHINE.
Disconnect from the power supply and allow the machine to
thaw. Inspect water tank for any damage or leaks. If
undamaged, refill with water and reconnect the power
supply
Fountain S.A.
17 Avenue de L’Artisanat,
B1420 Braine L’Alleud
Belgium
Tel +32 2 389 0800
Fax +32 2 384 2658
Stroke adjuster
Adjuster setting
Rocking
mechanism
Push
Hot water
Crème coffee
LED- indicator
