Foundry FastIron SuperX, Руководство по установке оборудования

Страница: 60 / 198

FastIron Hardware Installation Guide for the FSX, FSX 800, and FSX 1600
3 - 16 © 2008 Foundry Networks, Inc. December 2008
4. Re-attach the transparent cover that was removed in Step 1.
5. Connect the wire to your DC power source making sure to connect the positive and negative supply wires to
the correct location as marked on the power supply.
6. Observe the LEDs on the power supply front panel. The DC IN and DC OUT LEDs should be green (steady),
which indicates the power supply is providing power to the chassis components. If it is amber or OFF, the
power supply is not providing power to the chassis components. The ALM LED should be OFF.
Verifying Proper Operation
To verify the proper operation of the chassis after power on, you can do the following:
• Observe the LEDs
• Display the status of the modules using the CLI
Observing the LEDs
After the FastIron X Series chassis device powers on, you can observe its LEDs to verify that it initialized
successfully. Table 3.3 outlines the LEDs, the desired state of each LED, possible abnormal states of each LED,
and what to do if an LED indicates an abnormal state.
Table 3.3: Desired and Abnormal LED States After System Power On
LED Desired State Meaning Abnormal
State Meaning/Action
Management Module
+
–
Ground
DC Power
Chassis
Rear View Detail