Foundry NetIron MLX Series Installation and Basic Configuration Guide
3-46
© 2008 Foundry Networks, Inc.
December 2008
Figure 3.38 Installing a Power Supply in a NetIron MLX-32 Chassis
CAUTION:
Carefully follow the mechanical guides on each side of the power supply slot and make sure the
power supply is properly inserted in the guides. Never insert the power supply upside down.
4.
Install a blank power supply faceplate into each slot that is empty after all of the power supplies have been
installed.
5.
After the power supply is fully inserted, push the power supply front panel toward the back of the chassis. This
action causes the power supply connector to seat into the backplane connector.
6.
Gently pull the release latch on the power supply front panel upward and toward the top of the power supply
front panel. This action locks the power supply in place.
7.
For information about connecting power to the chassis, see “Connecting AC Power to a NetIron MLX-32
Chassis” on page 3-46.
8.
For information about powering on the system, see “Powering-On the Power Source” on page 3-50.
Connecting AC Power to a NetIron MLX-32 Chassis
AC power is supplied through an AC power cord that is installed in the front of each power supply in the NetIron
MLX-32 chassis.
Pw
r
Ac
tiv
e
Pw
r
Ac
tiv
e
Pw
r
Ac
tiv
e
Pw
r
Ac
tiv
e
Pw
r
Ac
tiv
e
Pw
r
Ac
tiv
e
Pw
r
Ac
tiv
e
Pw
r
Ac
tiv
e
AC OK
DC OK
ALM
Latch Handle Open
Power Supply Indicators
Power Supply
Pull Down on Plunger
to Remove
AC OK
DC OK
ALM
Power Supply Blank Cover
Latch Handle Locked