Foundry NetIron MLX Series Installation and Basic Configuration Guide
2-14
© 2008 Foundry Networks, Inc.
December 2008
10/100/1000 Ethernet Interface Module (RJ-45)
Figure 2.8 shows the 20-port 10/100/1000 Ethernet module’s front panel.
Figure 2.8 20-port 10/100/1000 Copper Ethernet Module Front Panel
The front panel includes the following control features:
•
LEDs
•
Twenty 10/100/1000 Copper Ethernet ports
1 Gigabit x 48-T Module
Figure shows the 1 Gigabit x 48-T module’s front panel.
Figure 2.9
1
Gigabit x 48-T Module Front Panel
The front panel includes the following control features:
•
LEDs
•
8 ports of Mini-RJ21 connectors with each connector supporting 6 ports of 1GbE
The front panel includes eight Mini RJ-21 connectors that support six 1 Gigabit Ethernet ports each. A cable
connects from the RJ-21 connector on the interface module to a Mini RJ-21 connector on a patch panel. At the
patch panel, the ports are broken out into individual RJ-45 connectors for each port.
Cables and patch panels that support this module are available through any Tyco International distribution partner.
Information about these products is available at the following URL:
www.ampnetconnect.com/foundrynetworks
Table 2.6: Gigabit Ethernet Module LEDs
LED
Position
State
Meaning
Link/Active
As shown in
Figure 2.8 on
page 2-14.
On (solid)
A link is established with the remote port
(with no traffic).
Blinking
The port is transmitting and receiving
packets.
Off
A link is not established with the remote
port and no traffic is being passed.
