Foundry NetIron MLX Series Installation and Basic Configuration Guide
2-12
© 2008 Foundry Networks, Inc.
December 2008
The following 10 Gigabit optics are available from Foundry:
For more information about the fiber-optic transceivers and the cabling associated with them, see “Installing a
Fiber-Optic Module” on page 4-5.
FE/GbE (100/1000) Ethernet Interface Module (SFP)
Figure 2.8 shows the 20-port 100/1000 Ethernet mini-GBIC (or SFP) module’s front panel.
Figure 2.7 20-port 100/1000 Ethernet SFP Module Front Panel
The front panel includes the following control features:
•
LEDs - The LEDs to the left support the top
•
20 100/1000 Ethernet mini-GBIC (SFP) ports
Table 2.3: XFP-Compliant Optics for the 10 GbE Ethernet Interface Module
Part Number
Description
10G-XFP-SR
850nm serial pluggable XFP optic (LC), target range 300m over multi-mode fiber
10G-XFP-LR
1310nm serial pluggable XFP optic (LC) for up to 10km over single-mode fiber
10G-XFP-ER
1550nm serial pluggable XFP optic (LC) for up to 40km over single-mode fiber
10G-XFP-ZR
1550nm serial pluggable XFP optic (LC) for up to 80km over single-mode fiber
10G-XFP-ZRD-XXXX-AA
10GBase-ZR DWDM, XFP optic, 80km, 1530.33 to 1561.42
10G-XFP-CX4
10-Base-CX4, XFP transceiver, 15km, CX connector (supported only on integrated
XFP slot on FGS624XGP and FGS624XGP-POE)
Table 2.4: Gigabit Ethernet Module LEDs
Position
State
Meaning
Below each
Ethernet port
(Left-side LED
supports port in
top row while
right-side LED
supports port in
bottom row)
On or blinking
The port is transmitting and receiving
packets.
Off for an extended
period
The port is not transmitting or receiving
packets.
Port Status LEDs
(In each pair, the left most LED supports the port in the top row directly above it
and the right-most LED supports the port in the bottom directly above it )
