Body
1. Sync Cord
2. Power Cord
3. Instruction Manual
Accessories
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
11.
12.
13.
14.
15.
16.
17.
Power Socket Sync Cord Jack
Power Switch Flash Output Controller
Optical Control and Anti-Preflash Switch Modeling Lamp Switch Buzz Button
Test Button Flash Output Level Indicator
Slave Trigger Indicator
Modeling Lamp Indicator
Buzz Indicator
Charging Indicator Lamp
Fuse
Mounting Bracket
Umbrella Input
Light Sensor
Flash Preparation
Test Button
Attach the flash unit on an
appropriate light stand.
Adjust the mounting bracket
(15) for a good angle and
make sure it's tightened and
fixed.
The umbrella input (16) is
applicable for any studio
umbrella.
Power Connection
Connect the flash to an AC power source via power cord and turn on the power switch
(3). The charging indicator lamp (13) remains off, indicating the unit is charging, no
flash at this moment. When the unit is ready to fire, the charging indicator lamp (13)
is on.
Flash Output Control
Flash output controller (4) controls the power radio, adjustable power from 1/8 to full.
It can meet customers' requirements for light in different environment. (Note: When
adjusting the power from full power to a lower setting, press the test button to release
the power in the capacitor, so when recharged, the flash output will be in the
corresponding setting.)
To fire the flash without taking a picture, push the test button. It will also adjust the
brightness when combined with the flash output controller (4).
Sync Triggering
The sync cord jack (2) is
a ÷3.5mm mini plug.
When working with sync
cord triggering method,
insert one end of sync
cord or a trigger plug
into it; the flash then
can be fired synchronously.
1
2
17
4
1
5
2
3
8
6
10
16
15
7
13
12
11
14
9
Names of Parts
Operations
04
03
Do not flash directly towards unprotected eyes (especially those of babies), otherwise
it may lead to short time visual impairment.
When not in use, disconnect from the power supply.
High voltage inside the tube outlets, please do not touch it. Hands should be dry
with insulated gloves when load/unload the flash tube and modeling lamp.
4. Bowens Mount Ring
